View Article |
Tool wear propagation in Ti6Al4V laser assisted micro milling using micro ball end mill
Zazuli Mohid1, Rahim, E.A2.
This paper presents an experimental study of laser
assisted micro milling of Ti6Al4V using micro ball end mill.
Tool wear propagation was observed and compared
between conventional and laser assisted micro milling to
evaluate the effectiveness of laser assisted machining
technique in Ti6Al4V micro machining. It is confirmed that
laser assisted micro milling technique managed to
improve the tool life even when using micro ball end mill
tool. The tools in laser assisted micro milling served
different tool wear mode compared to conventional micro
milling. The maximum flank wear in laser assisted micro
milling reduced for approximately 50 % at machining
distance of 6000 mm when the laser pulse width is
increased from 1 to 2 ms.
Affiliation:
- Universiti Tun Hussein Onn Malaysia, Malaysia
- Universiti Tun Hussein Onn Malaysia, Malaysia
|
|
Indexation |
Indexed by |
MyJurnal (2021) |
H-Index
|
5 |
Immediacy Index
|
0.000 |
Rank |
0 |
Indexed by |
Scopus 2020 |
Impact Factor
|
CiteScore (0.2) |
Rank |
Q4 (Surfaces, Coatings and Films) Q4 (Materials Chemistry) Q4 (Mechanical Engineering) Q4 (Surfaces and Interfaces) Q4 (Mechanics of Materials) |
Additional Information |
SJR (0.132) |
|
|
|