View Article |
Fabrication of 2D membrane castellated and straight electrode for dielectrophoresis
Farahdiana Wan Yunus1, Azrul Azlan Hamzah2, Muhamad Ramdzan Buyong3, Jumril Yunas4, Burhanuddin Yeop Majlis5.
This paper is presenting two fabrication process of electrodes for the used in artificial kidney.
The electrodes were made to compare which will represent the best results. Both electrodes
undergoes same fabrications process which represent the novelty in this research.
Membranes were fabricated in between the electrodes. Both electrodes were deposited with
aluminium. Later both electrodes were tested experimentally to find out the result of
particles on which electrode performs better. The experiment was taken for 3 minutes on
each frequencies. Frequencies were taken during the positive DEP only which are between
100kHz until 3 MHz. The results shown that castellated electrodes able to cleared the
particles much faster than straight electrodes. The faster particles cleared the pathways,
which resulting particles moving towards the electrodes, this shows higher electric fields is
produced. Higher electric fields shows that less voltage needed. Higher voltage has also been
avoided in this research in order to avoid the change of biological nature of cells
Affiliation:
- Universiti Kebangsaan Malaysia, Malaysia
- Universiti Kebangsaan Malaysia, Malaysia
- Universiti Kebangsaan Malaysia, Malaysia
- Universiti Kebangsaan Malaysia, Malaysia
- Universiti Kebangsaan Malaysia, Malaysia
Download this article (This article has been downloaded 53 time(s))
|
|
Indexation |
Indexed by |
MyJurnal (2021) |
H-Index
|
2 |
Immediacy Index
|
0.000 |
Rank |
0 |
Indexed by |
Scopus 2020 |
Impact Factor
|
CiteScore (1.3) |
Rank |
Q3 (Electrical and Electronic Engineering)) Q4 (Electronic, Optical and Magnetic Materials) |
Additional Information |
SJR (0.298) |
|
|
|