Complex components of the sheet metal forming process need to be designed with high precision and accuracy in order to prevent defects and misalignment of the end products. One of the sheet metal cool stamping process for these complex automotive components is burring which is the forming of a flange around a hole made in a piece of sheet metal. Springback is a common defect during the burring process. The aims of this paper are to investigate the springback effect and improve shape accuracy of hole burring by inner burring process of lower arm part for automotive lower arm part. The springback defects at hole burring usually happened on the inner burring process. Experimental stretch flanging for cold stamping process of inner burring process was used to investigate the reasons of springback effect around the burred hole for a lower arm part of high strength steel (HSS) sheets SPFH590. From the two designs of burring punch dies, the result shows the values of springback effect for clearance -0.15 which have a big gap at hole burring A arm and B arm diameters, are larger than clearance -0.34 which have small gap for inner burring process of lower arm part. The experimental analysis shows that springback is proportionally related to the punch-die clearance parameter of the tool profile where the springback increase as the clearance increases.