MyJurnal - Malaysian Citation Centre

Hardware in the loop of two rotors platform

Nur Amalina Musa; Shuhaimi Mansor; Airi Ali.

Flow visualization and measurement of a synthetic jet actuator performance using PIV system

Mansor, S; Dahalan, M.N; Lee, Z.K; Ali, A.

Effect of velocity variation at high swirl on axial flow development inside a can combustor

Mohamad Shaiful Ashrul Ishak; Mohammad Nazri Mohd. Jaafar.

Film cooling effectiveness in a gas turbine engine: a review

Ehsan Kianpour; Nor Azwadi Che Sidik; Iman Golshokouh.

Observation on solid propellant ignition using high speed camera: the effect of hot wire position on the combustion flame contour

Wan Khairuddin Wan Ali; Ang Kiang Long; Mohammad Nazri Mohd. Jaafar.

Flame and emission characteristics of a premixed swirl-stabilised burner

Chen, Wei Kew; Cheng, Tung Chong; Jo-Han, Ng; Boon, Tuan Tee; Mohamad Nazri Mohd Jaafar.

Static and dynamic balancing of helicopter tail rotor blade using two-plane balancing method

Mohd Shariff Ammoo; Ziad Abdul Awal; Norhidayah Mat Sangiti.

Structural analysis of UTM single-seat helicopter chassis

Mohd Shariff Ammoo; Ziad Abdul Awal; Khairul Shamil Khairudin.

Numerical prediction of blended wing body aerodynamic characteristics at subsonic speed

Pang, Jung Hoe; Nik Ahmad Ridhwan Nik Mohd.

Post-impact investigation of CFRP laminated plate

Israr, H.A; Hongkarnjanakul, N; Rivallant, S; Bouvet, C.

Effect of nitrogen dilution on the lean blowout limit and emissions of premixed propane/air swirl flame

Cheng, Tung Chong; Chen, Wei Kew; Jo-Han, Ng; Boon, Tuan Tee; Mohamad Nazri Mohd Jaafar.

Comparative results of a developed vehicle dynamic model for a sedan electric vehicle

Md Nazri Othman; Nur Maisarah Mohd Sobran; Kasrul Abdul Karim; Ismadi Bugis; Auzani Jidin.

Optimization control system using the quantum behaved particle swarm optimization on vehicle steering control system with steer-by-wire system

Fachrudin Hunaini; Imam Robandi; Nyoman Sutantra.

Development of integrated monitoring system for re-electric vehicle

Kasrul Abdul Karim; Md Nazri Othman; Auzani Jidin; Abdul Rahim Abdullah; Mohd Zulkifli Ramli.

A review on integrated active steering and braking control for vehicle yaw stability system

Aripin, M.K; Sam, Y.M; Kumeresan, A.D; Ismail, M.F; Peng, Kemao.

Ride comfort performance improvement of electric vehicle (EV) conversion using SAS-controlled active suspension system

Saiful Anuar Abu Bakar; Ryosuke Masuda; Hiromu Hashimoto; Takeshi Inaba; Hishamuddin Jamluddin; Roslan Abdul Rahman; Pakharuddin Mohd Samin.

Experimental study of electro-mechanical dual acting pulley continuously variable transmission ratio calibration

Bambang Supriyo; Kamarul Baharin Tawi; Hishamuddin Jamaluddin; Mohamed Hussein.

Brake wear particle size and shape analysis of non-asbestos organic (NAO) and semi metallic brake pad

Hussain, S; Abdul Hamid, M.K; Mat Lazim, A.R; Abu Bakar, A.R.

Effect of brake pad design on friction and wear with hard particle present

Abdul Hamid, M.K; Shasudin, N.I; Mat Lazim, A.R; Abu Bakar, A.R.

Study of alternative lubricants for cold extrusion process of A1100 pure aluminum

Nurul, M.A; Syahrullail, S.

Influence of normal load and temperature on tribological properties of Jatropha oil

Golshokouh, I; Syahrullail, S; Ani, F.N.

The effects of voids on the flexural properties and failure mechanisms of carbon/epoxy composites

Suhot, M.A; Chambers, A.R.

Loading rate effect on flexural and indentation behaviour of foam core composite sandwich panel

Azwan, S; Yazid Yahya; Abdi, B; Amran Ayob.

The effect of inlet air preheat on CO and NO production in the combustion of diesel in canister burner

Mohamad Shaiful Ashrul Ishak; Mohammad Nazri Mohd Jaafar; Wan Zaidi Wan Omar.